I tried to clean the residue off with isopropyl alcohol, but the stain on the board did not reduce. I plan to swap out the MB as soon as I get new thermal pads on all of the cards. So I am concerned that the fluid went down into the PCIe slot. dmesg shows the following error at boot:Īmdgpu 0000:47:00.0: Invalid PCI ROM header signature: expecting 0xaa55, got 0xffffĪnd compute intermittently hangs on all of the cards (not at the same time). I am still having problems on the system with the remaining 3 cards. I did get feedback on IG that the liquid is likely Silicone oil, which is non-conductive and should not cause a problem, but this card was pulled out of the system because it would cause the system to crash within seconds if it were enabled. 2x Fujipoly Thermal Pad Thermal Putty High Quality For Laptop GPU Heatsink. This significantly increases surface contact with a heatsink and improves cooling performance. They easily fit and adhere to most all shapes and sizes of components, including protrusions and recessed areas. The FujiPoly looks most interesting, but Grizzly may be easier to acquire. Fujipoly / mod/smart Extreme X-e Thermal Pad - 100 x 15 x 0.5 - Thermal Conducti. Fujipoly Ultra Extreme XR-m Thermal Pad - 60 x 50 x 1.0 - Thermal Conductivity 17.0 W/mK 32.99 Free Shipping Direct from PrimoChill Tyler Direct StoreVisit Store Add to cart Compare Fujipoly Extreme Xe Thermal Pad 100 x 15 x 10 Thermal Conductivity 110 WmK 44. The new 13 Watt Sarcon® Thermal Gap Filler Pads are highly conformable and high heat-conducting gel materials in a versatile sheet form. I will have to see what I can get here in Taiwan. Thanks for the thermal pad recommendations.
0 Comments
Leave a Reply. |